Product code: 51946
The converter enables bidirectional signal conversion between a wired Ethernet network and a fibre-optic network. Two RJ45 ports and two fibre-optic sockets allow you to expand your network, increase the transmission range and ensure a stable connection that is resistant to electromagnetic interference. LEDs indicate the power status, active connections and transmission speed.

A stable and fast local area network free from electromagnetic interference
A reliable and high-performance network device that converts signals from an RJ45 cable (10/100/1000 Mbps) to fibre optic and vice versa at a transmission speed of 1000 Mbps. It ensures a stable and fast connection and smooth data transmission. The device operates bidirectionally – it supports both sending and receiving data in Full-Duplex or Half-Duplex mode. This functionality allows you to significantly expand the capabilities of your network infrastructure, without the need for complex solutions or incurring the costs of investing in additional equipment.

Bi-directional data transmission at up to 1 Gb/s, Full/Half Duplex
Discover new possibilities with the Qoltec device, which offers:
• Supports simultaneous data transmission and reception in Full-Duplex or Half-Duplex mode,
• Equipped with 2 RJ45 ports and 2 SFP ports,
• SFP data transfer speed up to 1 Gb/s,
• Packet forwarding rate of 14.388 Mpps,
• Internal bus bandwidth of 8 Gb/s,
• 2K MAC address table,
• Metal housing,
• LED indicators for status and connection activity,
• Compatible with CAT 5, 5e, 6, 7 and 8 patch cables
• Provides high resistance to electromagnetic interference and stable data transmission even over longer distances.
Simple and quick installation in just a few steps, with automatic connection detection
Our device offers instant and hassle-free installation, thanks to Plug & Play technology, which requires no additional configuration or specialist technical knowledge. The device is ready for use almost immediately after connection; all you need to do is follow a few simple steps:
• Insert the appropriate SFP modules into the Fiber 1 and Fiber 2 sockets on the converter,
• connect the fibre optic patch cords to the installed SFP modules,
• connect network devices, such as a router, switch, modem, computer or recorder, to the RJ45 ports labelled 1X and 2X,
• Connect the power supply and ensure that the LEDs indicate activity on the ports.
Product with 24 months guarantee
Do you care about the high quality of the product you buy? Our solutions will meet your expectations. The product is covered by a 24-month warranty valid from the day of purchase.
If you have problem with this product please contact us using this form.
You can also contact us using telephone, phone numbers are in contact.
You can find our product in well known stores with electronic equipment.
Ntec is an exclusive distributor of Qoltec product in Poland www.en.b2b.ntec.eu











